Your partner for research, development and innovation
  • CZ
  • ENG
  • RU
Application and implementation
Center of Engineering Research & Develoment
Laser Application Centre

Automatic Transfer Line BRUSHING

The machine is intended to a machining of metal pipe ends using brushing technology. By means of a brush, the polyamide layer protecting the pipe against mechanical damage is pulled off while preserving the basic zinc layer. The device is adapted for processing metal pipes in a diameter of 4.76 and 6.35 mm. The length of machined pipes is 338 up to 3200 mm. The machine cycle will be approx. 5 seconds according to technologies.

 


The entire cycle of machining is automated and after completing the respective operations, the pipe gets out from the machine at the exit where the operator removes it.

 




  • atl brushing předek.png
  • atl brushing 1.png
  • atl brushing 4.png
  • atl brushing 5.png
  • atl brushing 6.png
  • atl brushing 7.png
  • atl brushing 8.png
  • atl brushing 3.png

Address: VÚTS, a.s. | Svárovská 619 | Liberec XI - Růžodol 1 | 460 01, Liberec XI | Czech Republic

Contact: Phone: +420 485 301 111 | Fax: +420 485 302 402 | Email: vuts@vuts.cz | 

 

Copyright © 2022 - VÚTS Liberec
Vyrobila společnost Nový Web s.r.o.